Network Working Group
Internet Engineering Task Force (IETF)                      M. Boucadair
Internet-Draft
Request for Comments: 8113                                  C. Jacquenet
Updates: 6830 (if approved)                                                     Orange
Intended status:
Category: Experimental                           February 2, 2017
Expires: August 6,                                        March 2017

   LISP
ISSN: 2070-1721

                 Locator/ID Separation Protocol (LISP):
  Shared Extension Message & IANA Registry for LISP Packet Type Allocations
                      draft-ietf-lisp-type-iana-06

Abstract

   This document defines specifies a registry for Locator/ID Separation Protocol (LISP) Packet Type allocations.  It also specifies a LISP
   shared message type for defining future extensions and conducting
   experiments without consuming a LISP packet type codepoint for each
   extension.

   This document updates RFC6830 by defining  It also defines a registry for LISP Packet
   Types assignments.

Requirements Language

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in Type
   allocations, thus updating RFC 2119 [RFC2119]. 6830.

Status of This Memo

   This Internet-Draft document is submitted in full conformance with the
   provisions of BCP 78 not an Internet Standards Track specification; it is
   published for examination, experimental implementation, and BCP 79.

   Internet-Drafts are working documents
   evaluation.

   This document defines an Experimental Protocol for the Internet
   community.  This document is a product of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list  It represents the consensus of current Internet-
   Drafts is at http://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid the IETF
   community.  It has received public review and has been approved for
   publication by the Internet Engineering Steering Group (IESG).  Not
   all documents approved by the IESG are a maximum candidate for any level of six months
   Internet Standard; see Section 2 of RFC 7841.

   Information about the current status of this document, any errata,
   and how to provide feedback on it may be updated, replaced, or obsoleted by other documents obtained at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on August 6, 2017.
   http://www.rfc-editor.org/info/rfc8113.

Copyright Notice

   Copyright (c) 2017 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   2
   2.  Requirements Language . . . . . . . . . . . . . . . . . . . .   3
   3.  LISP Shared Extension Message Type  . . . . . . . . . . . . .   3
   3.
   4.  Security Considerations . . . . . . . . . . . . . . . . . . .   3
   4.
   5.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .   3
     4.1.   4
     5.1.  LISP Packet Types . . . . . . . . . . . . . . . . . . . .   3
     4.2.   4
     5.2.  Sub-Types . . . . . . . . . . . . . . . . . . . . . . . .   4
   5.  Acknowledgments
   6.  References  . . . . . . . . . . . . . . . . . . . . . . .   4
   6. . .   5
     6.1.  Normative References  . . . . . . . . . . . . . . . . . .   5
     6.2.  Informative References  . . . . . . .   4
     6.1.  Normative references . . . . . . . . . .   5
   Acknowledgments . . . . . . . .   4
     6.2.  Informative References . . . . . . . . . . . . . . . . .   5   6
   Authors' Addresses  . . . . . . . . . . . . . . . . . . . . . . .   5   6

1.  Introduction

   The Locator/ID Separation Protocol (LISP, [RFC6830]) (LISP) base
   specification specification,
   [RFC6830], defines a set of primitives that are identified with a
   packet type code.  Several extensions have been proposed to add more
   LISP functionalities.  For example, new message types are proposed in
   [I-D.ietf-lisp-ddt], [I-D.zhao-lisp-mn-extension],
   [I-D.boucadair-lisp-bulk], [I-D.ermagan-lisp-nat-traversal],
   [LISP-DDT], [LISP-MN-EXT], [LISP-BULK], [NAT-LISP], or
   [I-D.boucadair-lisp-subscribe].
   [LISP-SUBSCRIBE].  It is expected that additional LISP extensions
   will be proposed in the future.

   In order to ease the tracking of LISP message types, this document
   proposes to create a "LISP Packet Types" IANA registry (see
   Section 4). 5).

   Because of the limited type space [RFC6830] and the need to conduct
   experiments to assess new LISP extensions, this document specifies a
   shared LISP extension message type and proposes a procedure for
   registering LISP shared extension sub-types (see Section 2). 3).

   Concretely, one single LISP message type code is dedicated to future
   LISP extensions; sub-types are used to uniquely identify a given LISP
   extension making use of the shared LISP extension message type.
   These identifiers are selected by the author(s) of the corresponding
   LISP specification that introduces a new LISP extension message type.

2.  Requirements Language

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [RFC2119].

3.  LISP Shared Extension Message Type

   Figure 1 depicts the common format of the LISP shared extension
   message.  The type field MUST be set to 15 (see Section 4). 5).

        0                   1                   2                   3
        0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
       +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
       |Type=15|        Sub-type       |   extension-specific          |
       +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
       //                    extension-specific                       //
       //                                                             //
       +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

               Figure 1: LISP Shared Extension Message Type

   The "Sub-type" field conveys a unique identifier that MUST be
   registered with IANA (see Section 4.2). 5.2).

   The exact structure of the 'extension-specific' portion of the
   message is specified in the corresponding specification document.

3.

4.  Security Considerations

   This document does not introduce any additional security issues other
   than those discussed in [RFC6830].

4.

5.  IANA Considerations

4.1.

5.1.  LISP Packet Types

   IANA is requested to create has created a new protocol registry for LISP Packet Types,
   numbered 0-15.  The registry must be is initially populated with the
   following values:

   Message                           Code    Reference
   ================================= ==== ===============
   Reserved                           0      [RFC6830]
   LISP Map-Request                   1      [RFC6830]
   LISP Map-Reply                     2      [RFC6830]
   LISP Map-Register                  3      [RFC6830]
   LISP Map-Notify                    4      [RFC6830]
   LISP Encapsulated Control Message  8      [RFC6830]
   LISP Shared Extension Message     15   [This document]      [RFC8113]

   The values in the ranges 5-7 and 9-14 can be assigned via Standards
   Action [RFC5226].  Documents that request for a new LISP packet type
   may indicate a preferred value in the corresponding IANA sections.

4.2.

5.2.  Sub-Types

   IANA is requested to create a has created the "LISP Shared Extension Message type Type Sub-types"
   registry.  No initial values are assigned at the creation of the
   registry; (0-4095) are available for future assignments.

   The values in the range 0-1023 are assigned via Standards Action.
   This range is provisioned to anticipate, in particular, the
   exhaustion of the LISP Packet types.

   The values in the range 1024-4095 are assigned on a First Come, First
   Served (FCFS) basis.  The registration procedure should provide IANA
   with the desired codepoint and a point of contact.  Providing contact; providing a short
   description (together with an acronym, if relevant) of the foreseen
   usage of the extension message is also encouraged.

5.  Acknowledgments

   This work is partly funded by ANR LISP-Lab project #ANR-13-INFR-
   009-X.

   Many thanks to Luigi Iannone, Dino Farinacci, and Alvaro Retana for
   the review.

   Thanks to Geoff Huston for the RtgDir directorate review.

6.  References

6.1.  Normative references References

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119,
              DOI 10.17487/RFC2119, March 1997,
              <http://www.rfc-editor.org/info/rfc2119>.

   [RFC5226]  Narten, T. and H. Alvestrand, "Guidelines for Writing an
              IANA Considerations Section in RFCs", BCP 26, RFC 5226,
              DOI 10.17487/RFC5226, May 2008,
              <http://www.rfc-editor.org/info/rfc5226>.

   [RFC6830]  Farinacci, D., Fuller, V., Meyer, D., and D. Lewis, "The
              Locator/ID Separation Protocol (LISP)", RFC 6830,
              DOI 10.17487/RFC6830, January 2013,
              <http://www.rfc-editor.org/info/rfc6830>.

6.2.  Informative References

   [I-D.boucadair-lisp-bulk]

   [LISP-BULK]
              Boucadair, M. and C. Jacquenet, "LISP Mapping Bulk
              Retrieval", draft-boucadair-lisp-bulk-03 (work in
              progress), July 2016.

   [I-D.boucadair-lisp-subscribe]
              Boucadair, M. and C. Jacquenet, "LISP Subscription",
              draft-boucadair-lisp-subscribe-03 (work Work in progress), July
              2016.

   [I-D.ermagan-lisp-nat-traversal]
              Ermagan, V., Farinacci, D., Lewis, D., Skriver, J., Maino,
              F., and C. White, "NAT traversal for LISP", draft-ermagan-
              lisp-nat-traversal-11 (work in progress), August 2016.

   [I-D.ietf-lisp-ddt] Progress,
              draft-boucadair-lisp-bulk-04, February 2017.

   [LISP-DDT]
              Fuller, V., Lewis, D., Ermagan, V., Jain, A., and A.
              Smirnov, "LISP Delegated Database Tree", draft-ietf-lisp-
              ddt-09 (work Work in progress),
              Progress, draft-ietf-lisp-ddt-09, January 2017.

   [I-D.zhao-lisp-mn-extension]

   [LISP-MN-EXT]
              Wang, J., Meng, Y., and N. Zhao, "LISP Mobile Node
              extension", draft-zhao-lisp-mn-extension-02 (work Work in
              progress), Progress,
              draft-zhao-lisp-mn-extension-02, October 2011.

   [LISP-SUBSCRIBE]
              Boucadair, M. and C. Jacquenet, "LISP Subscription", Work
              in Progress, draft-boucadair-lisp-subscribe-04, February
              2017.

   [NAT-LISP]
              Ermagan, V., Farinacci, D., Lewis, D., Skriver, J., Maino,
              F., and C. White, "NAT traversal for LISP", Work in
              Progress, draft-ermagan-lisp-nat-traversal-11, August
              2016.

Acknowledgments

   This work is partly funded by ANR LISP-Lab project #ANR-13-INFR-
   009-X.

   Many thanks to Luigi Iannone, Dino Farinacci, and Alvaro Retana for
   the review.

   Thanks to Geoff Huston for the RtgDir directorate review.

Authors' Addresses

   Mohamed Boucadair
   Orange
   Rennes  35000
   France

   EMail:

   Email: mohamed.boucadair@orange.com

   Christian Jacquenet
   Orange
   Rennes  35000
   France

   EMail:

   Email: christian.jacquenet@orange.com