rfc8971v2.txt		rfc8971.txt
	skipping to change at line 300 ¶		skipping to change at line 300 ¶
	addresses. The IP address SHOULD be selected from the range		addresses. The IP address SHOULD be selected from the range
	127/8 for IPv4 and from the range ::ffff:127.0.0.0/104 for		127/8 for IPv4 and from the range ::ffff:127.0.0.0/104 for
	IPv6. Alternatively, the destination IP address MAY be set to		IPv6. Alternatively, the destination IP address MAY be set to
	VTEP's IP address.		VTEP's IP address.
	Source IP: IP address of the originating VTEP.		Source IP: IP address of the originating VTEP.
	TTL or Hop Limit: MUST be set to 255, in accordance with		TTL or Hop Limit: MUST be set to 255, in accordance with
	[RFC5881].		[RFC5881].
	The destination UDP port is set to 3785 and the fields of the BFD		The destination UDP port is set to 3784 and the fields of the BFD
	Control packet are encoded as specified in [RFC5881].		Control packet are encoded as specified in [RFC5881].
	6. Reception of BFD Packet from VXLAN Tunnel		6. Reception of BFD Packet from VXLAN Tunnel
	Once a packet is received, the VTEP MUST validate the packet. If the		Once a packet is received, the VTEP MUST validate the packet. If the
	packet is received on the Management VNI and is identified as a BFD		packet is received on the Management VNI and is identified as a BFD
	Control packet addressed to the VTEP, then the packet can be		Control packet addressed to the VTEP, then the packet can be
	processed further. Processing of BFD Control packets received on a		processed further. Processing of BFD Control packets received on a
	non-Management VNI is outside the scope of this specification.		non-Management VNI is outside the scope of this specification.
End of changes. 1 change blocks.
	1 lines changed or deleted		1 lines changed or added
This html diff was produced by rfcdiff 1.48. The latest version is available from http://tools.ietf.org/tools/rfcdiff/